Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Installation in Richardson, TX - What It Costs & How It Works
Garage Door Installation in Richardson typically runs $700-$2,200 for a standard single or double door, depending on material, insulation, and size. Most installations take 4 to 8 hours from the moment the old door comes off the track to the final trim piece going on. If you call us at (972) 980-5944, we’ll give you a flat, written price before any work begins - Clause 1 of The Haven Standard, and we don’t make exceptions.
Trusted Garage Door Installation for Richardson Homeowners
Garage doors in Richardson take a beating. Clay soil shifts under slab foundations, and that movement transfers to the track and the opening. A door that ran smooth when the house was built in 2014 might be binding at the header by 2026. We see it in Canyon Creek, in Reservation, in the brick streets of Richardson Heights - the door didn’t fail because it was cheap. It failed because the house moved and nobody adjusted for it.
Servo Garage Doors has operated here since 2015. Our installers are background-checked, uniformed, and trained to treat your garage opening like the structural opening it is - not a quick swap. We don’t ask you to trust us. We photograph what we find, put the price in writing, and hand you a documented photo record before the truck rolls away. That’s been our rule since day one, and it’s now Clause 4 of The Haven Standard: the customer sees the failed part before anyone quotes a replacement.
Call (972) 980-5944. A live person answers. That’s not a policy we advertise; it’s how the phone works here.
What Our Garage Door Installation Service Includes
Every job starts the same way: a flat, written price and a written scope of work, handed to you before anything gets unbolted. No verbal estimates. No “it depends once we open it up.” The price on the page is the price you pay, and if something changes once we’re inside the opening, we stop, show you the photo, and write a new number before turning a wrench. That’s the system.
New Door Installation
This is a full replacement - old door removed, new door installed in the same opening, track and hardware replaced as needed. Most Richardson homes built before 2010 have original doors with R-values around R-6; a new insulated steel door runs R-12 to R-18 and drops the garage temperature 15 to 20 degrees in August. We handle the haul-away on every New Door Installation, and the disposal paperwork is part of the written scope, not a surprise line item.
When a door is rusted through at the bottom panel or the sections have separated at the joints, you’re not preserving anything by repairing it. We’ll tell you straight, with a photo of the rot or the seam, and let you decide.
Single Car Door
A single-car opening is typically 8 feet wide by 7 feet tall, though some Richardson homes in the older pockets near Arapaho and Custer run 9 by 7. Single Car Door installations are the most common job we do in the city - they’re the garage on a lot of three-bedroom brick ranches, and they’re usually the first door in the house to fail because they get the most daily cycles.
We measure the opening, check the header and the legs for square, and only then quote the door. A single-car steel door with basic insulation in Richardson runs $700-$1,400 installed, depending on brand and insulation level.
Double Car Door
Double doors span 16 feet wide on most Richardson properties, and that’s where installation mistakes get expensive. A 16-foot door that’s off by half an inch at the header will bind at the spring line within a year. We set the track with a laser level, not a bubble, and we check the floor for slope before we set the bottom brackets.
A double steel door in Richardson runs $1,200-$2,200 installed. Wood doors and custom options go higher. We’ll quote the exact number in writing before work starts, and the quote includes the opener mounting if you’re replacing that at the same time.
Custom Garage Door
Custom means the opening isn’t a standard size, or the homeowner wants a specific look - full-view glass, carriage-house styling, a wood grain that matches the front door. Richardson has plenty of mid-century moderns in the Duck Creek area where a stock white panel door looks wrong on day one.
We don’t build custom doors in-house; we order from manufacturers who do, and we’re honest about lead times - most custom orders land in 3 to 6 weeks. The written quote includes the door, the freight, the installation, and the photo record at the end.
Steel Doors
Steel is the default for Richardson garages for good reason: it handles the summer heat without warping, it takes hail without denting (up to a point), and it’s the best insulation value per dollar on the market. We install steel doors from Clopay, Amarr, and Wayne Dalton, with R-values ranging from 6.5 on a budget panel to 18.4 on a triple-layer polyurethane-filled door.
One thing to know: steel panels on a south-facing garage in Texas will fade over time. If you’re buying, ask about the paint warranty. If we’re installing, we’ll have already put it in the written scope.
Wood Doors
Wood garage doors in Richardson are a statement, not a utility purchase - they run $2,000 and up, they need sealing every two to three years, and they weigh more than steel, which means the springs and opener have to be sized accordingly. We install wood doors where the aesthetic is the point: a cedar carriage door on a renovated Heights bungalow, a custom mahogany on a newer build near the Creek.
We quote wood doors with a material detail sheet attached - species, grade, seal schedule. If you’re spending that kind of money, the documentation should exist before the door shows up.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterBrands We Service for Garage Door Installation
We install and service LiftMaster openers on a weekly basis across Richardson, including the belt-drive models that are the standard for attached garages where a bedroom sits above. LiftMaster’s logic boards are straightforward, and we keep the common models on the truck. When we mount a new LiftMaster during an installation, we set the force limits with a door-run test, not the factory defaults - factory defaults are for a test lab, not a 16-foot door in a Collins Crossing garage.
We also work constantly on Chamberlain and Genie opener systems, and we install doors from Raynor, Clopay, Amarr, and Wayne Dalton. If you have a Raynor ShowCraft or a Clopay Gallery series, we’ve installed and balanced both, and we know the spring sizing charts for each panel weight. Whether you have one of those or something less common, we can quote it, order it, install it, and document it.
Signs You Need Garage Door Installation Right Now
- Visible rust or rot on the bottom panel. The bottom panel takes the weather. Once rust has eaten through the steel or rot has softened the wood, the panel loses structural integrity and the door goes out of balance. We photograph the panel before quoting a replacement - that photo is your evidence, not our opinion.
- The door sags or separates at the section joints. Sectional doors flex at the hinges. When the steel at the hinge line starts to tear or the wood splits along the stile, the door can separate mid-cycle. That’s a safety issue, not a cosmetic one. A door that separates while opening can drop.
- The door is original to a house built before 2005 and you’ve already done two spring replacements. Springs are wear parts. But a door that’s burning through springs faster than the schedule says it should is telling you the door weight or the balance is wrong. At some point the math says replace the door, not the coil.
- The door doesn’t seal at the bottom or the sides. Richardson summers push hot air into the garage, and that heat loads the wall between garage and house. If you can see daylight at the bottom weatherstrip and the track has been adjusted twice, the opening has probably shifted. A new installation with fresh track and a properly set perimeter seal fixes the load problem.
- The opener struggles and you’ve already replaced the opener. If a new opener still sounds like it’s fighting the door, the door is the problem - wrong spring size, worn rollers, or a track out of alignment. We’ll diagnose it properly and show you the measurements before recommending a new door install.
Our Garage Door Installation Process - Step by Step
- 1
Measure and inspect. We measure the opening in five places - header left, header right, mid-height left, mid-height right, and floor slope. We check the header for deflection and the legs for plumb. If the opening isn’t square, the new door won’t run square. We’ll show you the numbers.
- 2
Written quote. You get a flat, written price and a written scope of work before any work begins. That’s Clause 1 of The Haven Standard. The scope lists the door model, size, insulation R-value, opener (if included), disposal, and the warranty term. If you bring a written estimate from another company, we’ll give you a free second opinion on it - no coupon, no code, just bring the paperwork.
- 3
Removal and disposal. We pull the old door, the old track, the old springs, and the old opener (if replacing). We take everything with us. You don’t schedule a bulk pickup or make a second trip to the landfill.
- 4
Installation and setup. New door goes in, track set with a laser, springs wound to the exact turns for the door weight, opener mounted and force limits tested with a door-run cycle. We run the door three full cycles and listen. If it’s not quiet and smooth, we adjust until it is.
- 5
Documented photo record. Before we leave, we photograph the installed door, the spring assembly, the track, the opener mounting, and anything else that matters. You get those photos - not as a favor, as a policy. Clause 4 exists because in 2015, the first thing Marcus Deller ever promised a customer was proof of what was found and what was done. That rule hasn’t changed.
How Much Does Garage Door Installation Cost in Richardson?
A typical single-car steel door installation in Richardson runs (see our Garage Door Installation cost guide) $700-$1,400. A double-car steel door runs $1,200-$2,200. Those numbers include the door, the track, the hardware, the springs, the installation labor, and the haul-away. If you’re adding an opener, expect $250-$550 more for a belt-drive unit installed.
What moves the price: insulation level (an R-6 door costs less than an R-18 door, and the difference matters in a Richardson August), window inserts, custom colors, and whether the opener is being replaced at the same time. What shouldn’t move the price: a surprise disposal fee, a surprise “reinforcement” charge, or a verbal quote that changes after the old door is on the ground.
The way to avoid overpaying in Richardson is to get the price in writing before work starts - not a range, not a “probably in this ballpark,” an actual fixed number with a scope attached. That’s exactly what we deliver, every time, with no exceptions. And our written quote covers the photo record at the end. That’s included, not optional.
Garage Door Installation Near Richardson - Our Service Area
We install garage doors across Richardson and the surrounding North Dallas suburbs - Garage Door Installation in Plano, Garage Door Installation in Garland, plus Allen, Carrollton, Wylie, Frisco, Mesquite, McKinney, Heath, and Rockwall. Most installations in Richardson proper get scheduled within 3 to 7 days. If your door is damaged and you need it secured now, call (972) 980-5944 - we answer live, 24/7, including holidays.
Serving Richardson, TX - Our Local Coverage Area
We’re based in the Richardson area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions - Garage Door Installation in Richardson
Garage door installation means removing your existing door and track and installing a new door in the same opening, with new hardware, new track, and new springs sized to the new door’s weight. It can also include replacing the opener at the same time if you want the system to work as one unit. In Richardson, we treat every installation as a structural job - the opening gets measured, the header gets checked, and the new door gets installed square and balanced.
Most residential garage door installations take 4 to 8 hours, depending on the size of the door, whether the opener is being replaced, and how much of the old hardware needs to come out. A straightforward single-door swap in Richardson typically runs 4 to 5 hours. A double door with a new opener and significant track work can push 8. We’ll give you a clear timeline in your written scope before work starts.
A single-car door installation in Richardson runs $700-$1,400; a double-car door runs $1,200-$2,200. Opener installation adds $250-$550. The number that matters is the one we write on your quote before work begins - that’s the price you pay, period. Call (972) 980-5944 for an exact written quote; estimates are free and there’s no obligation.
Yes. We install LiftMaster, Chamberlain, Genie, and Raynor openers, and we service all eight major brands - meaning we can pull a compatible unit for whatever door you have or quote you the right opener for the new door going in. We set the force limits and travel on every opener we install using a door-run test, not factory defaults. Your new opener gets tested against your actual door, not the manual’s assumptions.
Yes. We answer live phone calls 24/7, including holidays, and we can dispatch a technician to secure a failed door, remove a door that’s jammed or partially fallen, or complete an installation on an urgent timeline. If your garage door has gone down and you can’t secure the opening, call (972) 980-5944 and you’ll speak to a person, not a recording. We’ll tell you what the technician will do and when the truck will be there.
Every installation carries the manufacturer’s warranty on the door and hardware, plus our 365-Day Done Right Promise: if the installation isn’t right, we make it right, backed by The Haven Standard and a terms page, not a handshake. The exact warranty terms for your specific door and opener are printed on your written scope before work starts, and the photo record we hand you at the end documents what was installed and how it looked when we left.
Clear the garage floor about 6 feet in from the door, move any vehicles out of the garage, and make sure there’s a clear path from the driveway to the garage. If you have items stored against the walls near the track, move them back a few feet so we have working room. We handle everything else - removal, disposal, and cleanup are all part of the written scope.
Schedule Your Garage Door Installation Service in Richardson Today
Getting a new garage door in Richardson starts with a phone call and ends with a written price, a documented photo record, and a door that opens like it’s held by springs, because it is. Call (972) 980-5944 for a free, no-obligation written estimate. No pressure, no urgency theater, just the price on paper before anything gets unbolted.
Written by Marcus Deller, Owner at Servo Garage Doors, serving Richardson since 2015.