Before & After Gallery - Servo Garage Doors Richardson

Garage Door Before & After in Richardson, TX

We could tell you we do clean work, but you’d be right to want proof. That’s why every Servo job closes with a documented photo record of what we found and what we did. The transformations below show the kinds of repairs and replacements we handle across Richardson, from Canyon Creek to Breckinridge Park. Real doors, real problems, real results.

Call (972) 980-5944

Recent Transformations

Torsion Spring Replacement on a Double-Wide Door

The homeowner called us around 7:15 a.m. because their garage door sounded like a gunshot and wouldn’t budge. We found the right-side torsion spring had snapped clean at the coil, leaving the door dead-weighted against the opener. Per Clause 4 of The Haven Standard, we photographed the failed spring before quoting the replacement. Both springs were replaced as a matched pair (standard practice, since the left one was the same age), the door was rebalanced, and the opener’s force settings were recalibrated. Total time on site: 68 minutes. The before photo shows the break; the after shows the door lifting evenly with two fingers’ worth of pressure.

Opener Logic Board Failure in a LiftMaster Unit

This one came to us after the customer had already replaced every battery in the house and still couldn’t get the door to respond. We traced the issue to a failed logic board in a 2019 LiftMaster 8550W, which we confirmed by testing wall-button continuity and checking voltage at the terminals. The board was replaced with an OEM part on the truck, not a generic knockoff. All three remotes and the exterior keypad were reprogrammed, and the limit switches were tested through a full open-close cycle. The customer received photos of the old board showing the burned trace and the new board installed, plus a written warranty for the part.

Full Door Replacement: Wood Composite to Amarr Steel

The original door was a 2004 wood composite that had absorbed years of North Texas humidity and heat. Two panels were delaminating, the bottom section was rotting where sprinkler overspray hit it, and the whole thing rattled every time it moved. We measured the opening, went over panel material options with the homeowner, and quoted a flat price for a new Amarr 3000 series steel door with insulation, new tracks, torsion springs, and a fresh weather seal. Written scope and price were agreed before anything was ordered. The old door was hauled off, the new one was installed in one day, and the after photo shows a door that opens without a sound and closes tight against the slab.

Off-Track Door with Bent Track Section

A work truck backed into the bottom panel of this garage door, shoving it off its rollers and kinking the left vertical track. The door was wedged about eight inches out of square, and the homeowner was rightly worried it would come down on someone. We reinforced the damaged panel, replaced the bent track section, and swapped all ten nylon rollers for new ones. The springs were then re-tensioned so the door sat level. Before leaving, we ran it through five full cycles. The after photo shows the door square in the opening and sealing properly along both sides. The written scope included exactly which parts were replaced and why.

Noisy Operation from Worn Hinges, Rollers, and a Loose Trolley

This customer thought their opener motor was going out because of the racket the door made every morning. What we found was simpler and less expensive: three worn hinges with ovaled pivot holes, steel rollers with flat spots, and a trolley carriage that had worked loose on the rail. We replaced the hinges and rollers, tightened the trolley, and lubricated the spring and bearings. In the after photo, the difference isn’t visual, it’s audible, so we included a short video clip in the document record we sent. The customer said it was like a different door.

Garage Door Opener Replacement: Chain Drive to Belt Drive

The old opener was a chain-drive from 2008 that took a full 18 seconds to cycle and rattled enough to wake anyone sleeping above the garage. We quoted a new Chamberlain B970 belt drive with battery backup, a new wall console, and a fresh exterior keypad. The difference in the before and after is visible in the head unit and the rail, but the real story is the noise level drop. The after photo shows the new unit mounted clean, wiring dressed, and the safety sensors aligned. The customer received the full photo record and the written warranty on the chamberlain opener before we pulled out of the driveway.

Want Results Like These?

Every job above started with one phone call and ended with a photo record and a written price honored to the dollar. Whether it’s a snapped spring, a dead opener, or a full replacement, we’ll tell you what’s wrong, what it costs, and what it’ll look like when we’re done, all before the work starts. Call (972) 980-5944 and talk to a real person, day or night.

Written by Marcus Deller, Owner at Servo Garage Doors Richardson, serving Richardson since 2015.